natural gas steam boiler best quality

WNS oil gas fired horizontal steam boiler best quality

Trust The horizontal boiler Experts at ZG Boiler

Fuel gas control step and the blowing process air volume of the total fuel gas steam boiler best quality steam boiler is achieved by adjusting a liquid coupling scoop blower. Organization fuel gas steam boiler combustion, is to make a, air pressure, air flow of secondary air with the good. Adjusting the amount of primary air should meet it carries the fuel into the furnace ignition of volatile oxygen required, and to maintain a certain speed, and without clogging the fuel discharge pipe of the jet having a certain rigidity. Primary air volume is too large and too small, the wind speed is too high and too low, should be avoided. In addition to adjusting the secondary air of combustion of the fuel should ensure that the oxygen demand, but must maintain a certain wind speed and primary air is mixed with the master time should have a strong stirring and mixing coke penetrate "the Gray" kinetic , which requires the case may be, each layer of the secondary air flow rate, in order to achieve stable combustion and flue gas excess oxygen appropriate destination. Fuel gas steam boiler, secondary air with what is better? Primary air volume air volume of the total share is called the primary air rate. A small air fraction, pulverized coal is heated to at least the heat required for the ignition point, fire faster, but the amount of primary air to satisfy the principle of combustion of volatiles. Secondary air mixed with the primary air time to the right. If it is mixed before ignition, means an increase in the amount of primary air, so that the ignition delay; hypoxia combustion secondary air if mixed will make late after ignition; if secondary air is mixed all at one position, since the secondary air temperature well below flame temperature, the flame temperature decreases, the combustion slows down, causing the fire. Therefore, the secondary air mixed with fuel should be based on the nature of the combustion zone as required timely sent, so that the combustion of oxygen, and will not reduce the flame temperature to ensure complete combustion and ignition stability. One or two wind speed with what is better? Fuel gas steam boiler once the wind speed is high, the fuel gas stream will catch fire in places far away from the burner, the ignition point postponed; once the wind speed is too low, it will cause a blocked ducts, and ignition point is too far forward, the burner will burn , but also easy to coke near the burner.

Exhaust gas has been plagued by sewage paper industry, paper industry pollution problems of the country very seriously. Fujian Heng paper packaging company has been committed to the use of clean-type boiler paper processing. October 22, 2016, David Carse, the paper with my company, signed a 6 tons of steam an integral condensing steam boiler best quality for the production of corrugated cardboard and other paper products. I provided the boiler greatly solve the problem of sewage wastewater Heng paper. After the boiler operation, both to meet local environmental requirements, but also reduce operating costs for the constant boiler paper products.

Factors industrial boiler energy-intensive factors which have high energy consumption of industrial boilers which 1, energy consumption is low management level industrial boiler is too large, there are currently a lot of long-term business. On the one hand understanding of the enterprise energy conservation boiler is still not sufficient, on the other hand the energy management level is still at a low level, and even some companies even the most basic measuring instruments are not equipped. In order to reduce operating costs, many companies have to buy the old boiler use, lack of components purchased fuel means of inspection. Even in the case of raw coal screening is not performed, it is directly put into production use, it is difficult to ensure full combustion of coal. Not only the thermal efficiency is low, but also resulted in a waste of fuel. 2, heat recovery is poor combustion is incomplete, the situation is the high rate of heat loss is extremely common in industrial boilers used in the process, saving the main parameters of the boiler will be exceeded. Economizer function is to heat energy recovered, but in actual use, heat recovery efficiency is very low. In this case, do not use a lot of boiler economizer direct altogether, inevitably produce exhaust gas temperature is too high. Meanwhile, return the device and steam condensate recovery, it has not been fully appreciated and better use, some are put to use in the boiler after installation, and did not take appropriate measures to deal with poor recycling effect. 3, lack of effective supervision of the level of energy service work, depends largely on the level of experience and technical personnel. But in practical terms, due to the lack of technical personnel, resulting in the energy service work at the level of the low. Various enterprises produced energy-saving products with high imitation, coupled with the lack of effective supervision of energy-saving measures, resulting in the entire market of energy-saving products more confusing. The effect of not only energy-saving effect is not ideal, and to transform the poor, the performance of energy-saving products remains to be greatly improved. Market confusion, vicious competition phenomenon has not been fundamentally curbed.